Page 6
Extender Advanced User Manual
Inclusion & Exclusion
Inclusion (Add to System)
1.
For proper inclusion, bring the Extender to the final location where it will
be
used*.
2.
Follow the instructions for your Z-Wave controller to enter inclusion mode.
3.
Supply power to the
Extender to begin inclusion mode. If the
Extender is already powered on, press the button 3 times quickly.
4.
The device will enter inclusion mode for two minutes and the LED Ring will
blink quickly (1 times/sec) until it’s included in a system.
Upon successful inclusion, the LED Ring will blink slowly three times and then
stay on permanently.
Exclusion (Remove from System)
Follow the instructions for your Z-Wave Certified Controller to enter exclusion
mode. When prompted by the controller:
1.
Make sure the
Extender is powered on.
2.
Press the Button quickly 3 times in a row.
Upon successful inclusion, the LED Ring blink slowly three times and then blink
once every half second until it is included in a system.
*For non Z-Wave Plus networks, please consult the owner’s manual for your primary controller to determine the best method/location for
adding the Extender to your Z-Wave network. A Security Enabled Z-Wave Controller must be used in order to fully utilize the product
Inclusion & Exclusion