68
69
Turn the inner side so that
you can feel the correct po-
sition of the cam and align
the Pro cylinder.
Fix the Pro cylinder with
the screw as soon as you
feel the correct position. Do
not completely tighten the
screw yet.
Insert the inside knob ac-
curately until it reaches the
end position.
Caution: Do not tighten the screw with a cordless
screwdriver without torque control, because you
could damage the Pro cylinder with the tool.
If necessary, turn the inside
knob with the shaft, thus
enabling free access of the
screwdriver to the set screw.
Hand-tighten the set screw
M3 (Torx T6) to the right with
the screwdriver (approx. 4
revolutions).
Check that both knobs turn
freely without scraping on
the fitting.
Tighten the screw.
PRO CYLINDER WITH CPP
VERSION READABLE ON ONE SIDE
Please note: Keep the original packaging so that
you can store the Pro cylinder safely at any time.
Fig. 5: Align cam
7
8
Fig. 6: Insert inside knob
9
10
11
12
13
Fig. 7: Tighten inside knob
Please note: Always make sure that you insert a
cylinder with core pulling protection into the cylin-
der hole from the inside to the outside. The side
with core pulling protection belongs on the outside.
Caution: In general, you should always install the
knob electronics first and then connect the battery
in order to prevent damage to the electronics.
Please note: The installation of protective fittings or
rosettes with round hole is described below; their
core covers generally have to be removed before
installation.
Measure the thickness of
the door with fitting.
Ensure that the basic length
of the cylinder is adapted
to the measured thickness:
Note the division into inside
(a) and outside (b).
Please note: Ideally, the door with fitting should be
a little thinner than the cylinder body of the cylin-
der, so that the knobs do not scrape on the fitting
and move freely.
1
2
Fig. 8: Measure the thickness
