90
91
If you have lost a locking medium, you can no longer individually
delete this locking medium (without the ENiQ® Access Manage-
ment or ELS software). In this case, you must delete all locking
media and set up the existing locking media again.
You only need a Programming Card to do this.
Please note: If you use the Master Card instead of
the Programming Card, all programming media will
also be deleted.
Follow the steps below:
3. Present the Programming Card twice, holding it flat a short
distance in front of the reading knob: The presentation of the
card is confirmed each time by two green flashes.
4. Present the Programming Card a third time, holding it flat a
short distance in front of the reading knob. The red LEDs will
flash twice as a confirmation.
All locking/programming media have been deleted.
Delete all locking media:
Delete all locking and programming media:
Please note: You must now set up the locking media
that you wish to reauthorise again (see page 76).
DELETE ALL LOCKING OR
PROGRAMMING MEDIA
The Pro cylinder has a radio interface by means of which data can
be exchanged with a PC/laptop.
There are two ways to do this:
„Offline“: Using a USB radio stick connected to the USB interface
of the PC or laptop.
„Online“: Using an RF NetManager to integrate the Pro cylinder
into a network and communicate with it directly.
You can also operate each Pro cylinder online later without ha-
ving to modify the cylinder in any way or to replace it.
If you have ENiQ® Access Management software or ELS software,
you have the option of managing and programming your Pro
cylinder. You can manage locking media and authorisations as
well as use additional functions that are only available via soft-
ware.
These include, among others:
• Read-out of the event memory
• Definition of time profiles
• Deletion of individual locking media that are no longer available
• …
In addition, using the software is more convenient and organised
in comparison with using Master Card programming.
PROGRAMMING AND
MANAGEMENT WITH SOFTWARE
