Dolphin Hybrid RS1, Operating Instructions Manual

Page: 7 / 44

Dolphin Hybrid RS 1 - Suction Pool Cleaner
| Operating Instructions
5
CAUTION
Operating above the MAX. may damage the Dolphin Hybrid Cleaner.
Table 1: Flow Indicator
Flow Indication Action
In satisfactory range Connect the Dolphin Hybrid Cleaner and begin the cleaning process.
Below MIN.
To correct the flow do one or more of the following:
• Make sure that the water level of the pool reaches the skimmer.
• Check that the hose is not twisted or bent near the pool connection.
If it is, use the 90° Adapter.
• Close unused skimmers or main drain. Make sure that the skimmer used
for the Dolphin Hybrid Cleaner is fully opened.
• Remove trapped air from the hose and Dolphin Hybrid Cleaner.
• Tighten connections between Hose Sections.
• Backwash the main filter and clean the skimmer and pump basket.
Above MAX.
• Open unused skimmers partially (if closed).
• If the Dolphin Hybrid Cleaner is connected to a dedicated suction line,
adjust its control valve on the pool pump.
• If the Dolphin Hybrid Cleaner is connected to a skimmer, reduce the
suction on the pool pump.
Connect the Dolphin Hybrid Cleaner
1
Make sure that the pool pump is switched OFF.
2 Disconnect the Flow Indicator (Drawing E) .
3 Make sure the Float is connected on the hose 40 cm
(1.30 ft) above the Dolphin Hybrid Cleaner.
4 Make sure that the hose is entirely under the water
level and is filled with water.
5 Hold the Dolphin Hybrid Cleaner by the handle and
put it in the water. Turn the Dolphin Hybrid Cleaner
upside down to remove any trapped air.
6 Connect the hose end to the Dolphin Hybrid Cleaner
(Drawing F) . Make sure that the hose is firmly
connected. Ensure that there is a small space between
the locknut and the pipe.
7 Realese the Dolphin Hybrid Cleaner in the pool.
Restart the pump
min max
E
3
6
F