Dolphin BC101-PR, Installation Instructions And Owner'S Manuals

Page: 12 / 14

P O LY E T H Y L E N E U N I T S
Each unit has four mounting ports based on a traditional
400mm stud spacing.
Two additional ports are provided for optional use.
All fixings are supplied with each unit to cater for fixing to
either solid masonry or studded wall constructions.
F I X I N G TO M A S O N RY
Secure the unit to brick and concrete block substrates
using four 5mm x min.75 mm wood screws into
proprietary wall plugs.
The flat fender washer is to be inserted underneath the
finishing washer. Finally, insert the snap-fit plastic covers in
each fixing port to cover the fixings.
A LT E R N AT I V E F I X I N G M E T H O D TO S T U DWO R K
The BC 100-EH/BC 100-EV unit can be fitted with the EZ Mount backer plate
to provide an alternative method of fixing to studded walls.
Two galvanised steel mounting bars are supplied, one pre-fixed to the rear of
the unit and the other loose for fixing to the wall. The wall bar has a multitude
of fixing holes to cater for variable stud positions.
1 Mark out and drill
fixing holes. Insert
toggle.
2 Twist toggle freely to
gain purchase on the
supporting member.
There should be a
minimum cavity clearance
of 65mm to allow the
toggle bar to turn.
3 Push the integral disc
along the toggle to
make a snug purchase on
the wall face. The toggle
strands are rachetted to
hold the disc in place.
4 Cut off the surplus
projection of the
toggle and offer up the
unit for fixing.
5 Align and engage the
fixing bolt in the
threaded toggle bar with
washers engaged. The flat
fender washer is to be
inserted underneath the
finishing washer. Finally,
insert the snap-fit plastic
covers in each fixing port.
R E C O M M E N D E D M O U N T I N G
H E I G H T S :
Standard – 900mm
Wheelchair – 750mm
N A P P Y C H A N G I N G U N I T I N S TA L L AT I O N
Polyethylene Units
Cover cap
Toggle
Fixing to studwork