Notice BEN.1225/40 rév 01
2
WARNINGS
Before Operation :
-
The manual contains vital and essential information. The owner should read and understand this
important document before operating the charger. Contact REYA if you do not understand a statement.
Before Installation :
-
In order to avoid overcharging or irreversible damage to the materials, please follow closely all
recommendations cited below. An owner should seek guidance from an authorized dealer or the factory.
-
Do not install this system near inflammable materials.
-
Do not install this system near a heat source.
-
It should not be installed in an airtight or badly ventilated area.
-
All ventilation ducts must be unobstructed.
-
Mount in a vertical position, to create natural ventilation for the charger. Note that the wiring connections
are at the bottom of the charger. Leave at least three inches clearance above and below the unit for
proper ventilation.
-
This system should not be exposed to water or dust.
-
It is strictly forbidden to tamper with the system casing.
Hazardous Conditions :
-
Can result from improper installation and:
•
Can cause serious injury or death of the occupants.
•
Can cause serious damage or destruction of the vessel.
Serial number :
-
The serial numbers are on the data plate which is located on the right side of the charger. These serial
numbers indicate the year, month, and sequence in which the charger was manufactured. The first letter
in the serial number represents the month it was manufactured (i.e. A-January, B-February, etc.). The
following two numbers represent the year the charger was manufactured and the remainder of the serial
number simply indicates the sequence in which that particular charger was manufactured.
BASIC INSTALLATION GUIDE
Connection precautions :
-
This system is set to be connected to a mono phase network 230V 50Hz or 115V 60Hz
-
There is an automatic 115V/230V selection.
-
For security reasons, the system's PE terminal must strictly be connected to the installation's Earth
(green/yellow wire in the cable section)
-
To prevent overheating, ensure the correct connection of cables.
-
NB: If an inverse polarization of the batteries occurs, the battery fuses will automatically blow.
Start up precautions :
-
In order to prevent all risk of electric shocks at either start up or during the utilization of this system, the
protection cap must rest in place and be tightly screwed.
Maintenance precautions :
-
In order to prevent risk of electric shocks during maintenance, please follow closely all recommendations
below before any maintenance begins.
-
Disconnect AC cable
-
-DC or
–
BAT cable must be disconnected in order to avoid transfer of energy.
-
Please wait 5 minutes before accessing into the casing
-
Fuses must be replaced by fuses that have the same characteristics and performance levels.
