5. The collar turns off on its own.
a. If no signal (beep, vibration or shock) is sent to the Receiver/Collar within 6-8 hours, it will go
into Sleep Mode (the collar will turn OFF). To use the units again, make sure to turn them ON.
b. This is designed to save power, but also to remind owners to check the prong’s contact with
their dog’s skin.
6.
How to “Pair” the Receiver/Collar with the Remote Control.
a.
The remote and receiver have been paired at the factory. Channel Display is “1”.
1)
To start, make sure the Receiver/Collar is turned OFF. To turn it OFF press and
hold the ON/OFF button on the top of the collar until it beeps and the indicator
will flash a red light.
2)
Make sure the remote is turned ON. To turn it ON you must twist the knob at
the top left of the remote clockwise.
3)
Press and hold the ON/OFF button on the collar until the light “quickly” flashes
green. (Don’t let go even if the collar beeps)
4)
Then, on the remote, press and hold the “Channel button” (button with the
numbers 1, 2, 9 on it). When it pairs the Receiver/Collar will vibrate and will go
back to flashing at a normal speed.
5)
Once the units are paired, the remote control display will show 1 and 30. To
make sure they are connected press the beep or vibrate button.
b.
Also here is a link about how to re-pair the older version receiver and the remote:
https://youtu.be/4XTecuRdahw
1.
Hold Static Level Regulator Activation button and Beep Button simultaneously for 8
secs. The Channel Display will default to "0".
2.
Connect the receiver with Power Source (matching mode can only be activated during
charging), then hold Channel Switch for 8 secs. The receiver will vibrate and beep,
which indicates matching is complete. You will see "1" in the Channel Display if
matching is successful.
7.
To Pair Additional Collars to the Remote. (TC01 can pair up to 9 collars on 1 remote).
a.
Repeat steps iii. and iv. from #6 (How to Pair the collar to the remote control).
1)
Press and hold the ON/OFF button on the collar until the light “quickly” flashes
green. (Don’t let go even if the collar beeps)
2)
Then, on the remote, press and hold the “Channel button” (button with the
numbers 1, 2, 9 on it). When it pairs the Receiver/Collar will vibrate and will go
back to flashing at a normal speed.
3)
Once the units are paired, the remote control display will show
2
and 30. (A 3
rd
collar, 3 and 30 and so forth). To make sure they are connected press the beep or
vibrate button.
8.
How to “Clear” Receivers/Collars from the Remote Control.
a.
To clear all matched receivers, on the remote press and hold the level and beep buttons at
the same time for approximately 3-7 seconds. It will
beep twice.
b.
The channel display will show zero.
