Dodge SLEEVOIL RTL 10, Instructions Manual

Page: 3 / 12

3
Tighten set screws to value specified in Table 1.
Install and
tighten jam screws 1/10 of torque specified for set screws.
Oil shaft in the bearing area and CAREFULLY set shaft in place.
Table 1
RTL
SLEEVOIL
SIZE
THRUST COLLAR
CLAMP SCREW SET SCREW
SCREW SIZE
(SOC. HEX)
WRENCH
TORQUE
(IN.-LBS.)
SCREW SIZE
(SOC.HEX)
WRENCH
TORQUE
(IN.-LBS.)
3 7/16 RTL ¼ - 20NC 160 5/16 - 24NF 160
315/16 RTL ¼ - 20NC 160 5/16 - 24NF 160
4 7/16 RTL ¼ - 20NC 160 5/16 - 24NF 160
415/16 RTL 5/16 - 18NC 325 5/16 - 24NF 160
5 7/16 RTL 3/8 - 16NC 580 3/8 - 16NC 275
6 RTL ½ - 13NC 1425 3/8 - 16NC 275
7 RTL ½ - 13NC 1425 3/8 - 16NC 275
8 RTL ½ - 13NC 1425 5/8 - 11NC 1200
9 RTL 5/8 - 11NC 2800 5/8 - 11NC 1200
10 RTL ¾ - 10NC 5000 5/8 - 11NC 1200
12 RTL ¾ - 10NC 5000 5/8- 11NC 1200
The thrust collar must be centered in the cavity of the liner base.
INSTALLATION OF OIL RINGS
NOTE: Do NOT use oil rings if liner cap has baffles installed
in the oil ring grooves.
Oil rings are shipped disassembled with two extra screws. Place
oil rings around outside of liner base and over shaft.
NOTE: Oil ring halves are match-marked and MUST NOT be
interchanged.
Place oil ring around outside of liner base and over shaft.
Install oil ring screws to insure they are secure. Repeat for
second ring.
Make sure oil rings rotate freely on shaft.
INSTALLATION OF THRUST PLATES
For non-expansion bearings:
Clean one set of babbitt faced thrust plates.
NOTE: Thrust plates are shipped in protective wax with the
babbitted faces on the outside. Be careful not to damage
the babbitted faces when peeling off the wax.
NOTE: Plates are matched halves and MUST NOT be
interchanged.
Carefully smooth any scratches on babbitted face with crocus
cloth (NOT emery cloth or sandpaper). Oil plate halves generously.