Dodge 2012 Challenger SRT8, Owner'S Manual

Page: 169 / 481

2. Place the hand-held transmitter 1 to 3 inches (3 to
8 cm) away from the HomeLink
威
button you wish to
program.
3. Simultaneously press and hold both the Homelink
威
button you want to program and the hand-held transmit-
ter button.
4. Continue to hold buttons until the EVIC display
changes from “CHANNEL # TRAINING” to “CHAN-
NEL # TRAINED”, then release both buttons.
NOTE:
•
It may take up to 30 seconds or longer in some cased
for the channel to train.
•
If the EVIC displays “DID NOT TRAIN” repeat from
Step 2.
5. Press and hold the programmed HomeLink
威
button.
The EVIC will display “CHANNEL # TRANSMIT”. If the
garage door opener/device activates, programming is
complete.
To program the remaining two HomeLink
威
buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
Reprogramming A Single HomeLink
威
Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink
威
button until
the EVIC displays “CHANNEL # TRAINING” Do not
release the button.
3. Without releasing the button proceed with “Program-
ming A Non-Rolling Code” Step 2 and follow all remain-
ing steps.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 167