4
SR835 Crossover
INSTALLATION
Install the crossover in a rack with the provided rack screws. Route the AC
power cord to a convenient power outlet away from audio lines. The unit may
be turned on and off using the front panel power switch. Since the units draw a
relatively small amount of current during idle, they can be left on continuously.
DOD crossovers generate very little heat during operation and thus do not
need to be specially ventilated or cooled. The units should not, however, be sub-
jected to high temperatures for extended periods. Although the unit's chassis is
shielded against radio frequency and electromagnetic interference, extremely
high RF and EMI fields should be avoided.
ATTENTION: Use only one Channel output connector for each frequency
range at a time. Using the balanced and unbalanced outputs for the same fre-
quency range at the same time can unbalance balanced lines, cause phase can-
cellation, short a conductor to ground, or cause damage to other equipment
connected to the crossover.
FOR BALANCED 1/4 “ TRS PHONE PLUG CONNECTION - Wire the con-
nectors as follows:
Phone Plug
Connection
tip
: high
ring
: low
sleeve
: ground
FOR 1/4" MONO PHONE PLUG CONNECTION:
Phone Plug
Connection
tip
: high
sleeve
: ground
Once the crossover has been installed and adjusted for the required cross fre-
quencies, and levels, an optional security panel can be installed to keep unautho-
rized persons from changing settings.
