44
SH-04D_E_02.fm
[44/63]
Before Using the Handset
Packet communication is also available while
Wi-Fi function is enabled. Wi-Fi connection is
prioritized while Wi-Fi connection is set, but the
connection will be automatically switched to that
of 3G/GPRS network once Wi-Fi connection is
terminated. Note that packet communication
charges will be incurred in such cases.
Refer to the manual of your wireless LAN base
unit when using the access point at home.
Operate access point registration near the
access point.
Enable Wi-Fi before setting.
1
In the home screen, [
R
]
/
[Settings]
/
[Wireless &
networks]
/
[Wi-Fi settings]
2
Select an item
Wi-Fi
: Enable Wi-Fi function.
Network notification
: You get notified by the
notification icon when open Wi-Fi network is
detected.
Wi-Fi sleep policy
: Set the timing to switch
Wi-Fi sleep.
Easy Wi-Fi registration
: Register AOSS/
WPS-compatible access point with each
method.
Auto login settings
: You can set the handset
to log in DOCOMO Public Wireless LAN
Service automatically when you come within
its service area.
Add Wi-Fi network
: Register access points
manually.
:
Available access points are displayed as
items in “Wi-Fi networks”. To connect, select
an access point to be used
/
[Connect].
･
If you select an access point protected by
security, enter the password (security key).
The radio interference with Bluetooth
devices
Wireless LANs (IEEE 802.11b/g/n) use the
same frequency band (2.4 GHz) as Bluetooth
devices. Therefore, using the wireless LAN
device near a Bluetooth device may cause
radio interference, lowering of communication
speed, noise or connection failure. In this
case, turn off the Bluetooth device or keep the
handset and the wireless LAN device at least
approximately 10 m away from the Bluetooth
device.
When you select an access point and connect to
it with a wrong password (security key),
[Connected (Limited)] is displayed. Confirm the
password (security key). When [Connected
(Limited)] is displayed after entering the correct
password (security key), you may not have
acquired the correct IP address. Connect to the
access point again after confirming signal status.
[Easy Wi-Fi registration]
The registration process takes a few minutes.
After completion of the registration of the
access point, check that the proper connection
to the access point is acquired.
[Auto login settings]
Separate subscription is required to use
DOCOMO Public Wireless LAN Service.
In some service areas, automatic login function
may be unavailable.
If you set Auto-login to [ON], the handset logs in
automatically when coming within the service
area. Note that high charges may be incurred if
your subscription is Mzone daily plan and you set
Auto-login to [ON].
SH-04D_E.book 44 ページ ２０１２年２月１３日 月曜日 午後５時１分