DoAll C-260 NC, Instruction & Parts Manual

Page: 12 / 59

Instruction & Parts Manual
Pag.12
Edition A
5. TYPE OF USE ALLOWED
5.1.
MACHINE
ADDRESSEE
This machine was design and built to comply a professional use, meaning that, besides the technical knowledge required, it is
necessary to have a specific knowledge to operate the saw to obtain the required goals.
5.2. O
PERATOR
The saw operator should have experience on similar type of machine. People with low or none experience must be educated,
followed and watched by a supervisor with enough experience and ability.
Therefore, the operator must be aware about dangers related to the use of this machine, and dangers due to normal handling
of metallic materials, similar, or heavy .
This machine cannot be used by people with handicaps or disables.
5.3. R
EGULATION
Designing and building this machine we respected the following laws and rules :
•
UNI rules
•
CEI rules
and more in detail, concerning the safety features (type A and B rules):
•
European Community Machine directive 89/392;
•
CEI-EN 60204-1 and related rules concerning electric’s, with respect of EC directive 73/23 ;
•
EN 292/1
•
EN 292/2
If not clearly specified, every component used on this machine was UNI and CEI approved at the time it was bought or
made.
5.4 T
YPICAL USE
This machine was designed and built to cut metallic materials fed by automatic systems and with overall size non larger than
the ones listed in the chart below (5.4). The saw can move :
1. movement of the material before and after each cut ;
2. vertical movement of the cutting bridge ;
3. blade rotation.
All these movements could take place at the same time.
The saw has the following performance :
Tab. 5.4