52
53
- Open the calibration tool
and select the item „Reset Magnification“ and
the option “Reset Picture Magnification”.
- Carry out a new calibration completely as described in the chapter “Calibration”.
- Change the magnification rate in this way and take some pictures. Load them into
the measuring and editing interface again by double-clicking on them in the list of
images on the right.
- Here, you open the calibration tool
again and select the item “Set
Magnification” as well as the option
„Reset Picture Magnification“.
- In the following dialogue window, enter
the current magnification rate, which is
accepted after clicking on “OK”.
- If you want to transfer this magnification rate to other loaded images, open the
calibration tool
after loading the image into the measuring and editing
interface and select the item “Set Capture Magnification” and the option “Set
Capture Magnification”.
- In the following dialogue window, you can now enter the current enlargement rate,
which is accepted after clicking on “OK”.
35
Change Calibration
If you need to change the magnification rate and adjust
focus to capture picture, please calibrate the
magnification rate again.
1. Double click to open the picture, Click ‘
>
Reset magnification > Reset picture magnification’ as
below. And then start calibration again (Calibration details
please refer to page24).
36
2. Change the magnification rate and capture several
pictures, click on the picture to enter into measurement
interface. And click ‘
> Set magnification > Set
picture magnification’, now a dialog will show up as below;
enter the magnification rate into the dialog and click ‘OK’.
37
3. If you want to use the same magnification rate to
capture pictures, just click ‘
> Set
magnification >Set capture magnification’. Now all
pictures will use the same magnification rate and you can
start measurement directly.
