Instructions for installation, setup and operation - FP9000L-2/4/6/8
Page
5
of
16
interruption) and automatic reset;
Ability to delay controllable and general outputs for fire for a period of 0 to 7 minutes
after the registration of state Fire,with DIP switch.;
Built-in sounder in case of fire – monotonal, continuous with the possibility of exclusion;
Test mode of each (fire alarm) lines;
Ability to Disable each of the fire alarm lines;
Ability to Disable controllable outputs for fire;
Interface for communication with external devices RS485 and networking / optional /;
Possibility for GPRS communication and remote control and monitoring / optional /;
Possibility Ability to add module relay M9000R-2/4/6/8. The module expands the outputs
of the Panel.
Over all size
310х240х80 mm
Weight without batteries
1,25 kg
Safety degree
IP30/ EN 60529
The panel meets standarts:
EN 54-2:1997
EN 54-2:1997/A1:2006
EN 54-2:1997/AC:1999
EN 54-4:1997
EN 54-4:1997/A1:2002
EN 54-4:1997/A2:2006
EN 54-4:1997AC:1999
EN 50130-4:2011
EN 55022:2006/А1:2007
EN 60950-1:2006/А11:2009
3. CONTROLS AND INDICATION
LED indicators
Indicators
Function
“POWER”
Constant green light
“FIRE”
Common indicator - flashing or constant red light in Fire condition
“DIST FIRE”
Flashing or continuous red light in case of a remote station Fire while working
in a network of more than one panel.
“FAULT”
A common failure indicator. Upon failure of any type a yellow light will start
flashing
“SYS FAULT”
A system failure due to stoppage of the CPU. A constant yellow light will
light up. Needs to be repaired at an authorized service.
“POWER FAULT”
In case of fault or loss of an AC or battery power supply a steady yellow light
will light up.
“TEST”
When in line test condition a constant yellow light will light up.
