DMT Controller Pixelstrip MKII, Manual

Page: 9 / 28

Ordercode: 42273
Controller Pixelstrip MKII
Control Modes
There are 3 modes: • Auto Mode
• Master/Slave
• DMX-512 (8CH, 480CH)/ArtNet/KlingNet
One Controller (Auto Mode)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Controller is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 14 for more information about Auto Mode.
Multiple Controllers (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Controllers.
The pins: 01) Earth
02) Signal -
03) Signal +
03) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX signal cable. Repeat this process to link the second, third, and fourth units.
04) Connect the first PixelStrip’s RJ45 "out" socket with the second PixelStrip’s RJ45 "in" socket, using a
CAT-5/CAT-6 cable. Repeat this process to link the second, third and fourth PixelStrip.
05) You can use the same functions on the master device as described on page 14 (Auto Mode).
This means that you can set your desired operation mode on the master device and all slave
devices will react the same as the master device.
Multiple Controllers (Master/Slave control)
Fig. 03
8