DMT Controller Pixelstrip MKII, Manual

Page: 10 / 28

Ordercode: 42273
Controller Pixelstrip MKII
Multiple Controllers (DMX Control)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Controllers and other devices.
04) Link the units as shown in fig. 04. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX signal cable. Repeat this process to link the second, third, and fourth units.
05) Connect the first PixelStrip’s RJ45 "out" socket with the second PixelStrip’s RJ45 "in" socket, using a
CAT-5/CAT-6 cable. Repeat this process to link the second, third and fourth PixelStrip.
06) Supply electric power: Plug electric mains power cords into each unit's Blue/White socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Controllers DMX Set Up
Fig. 04
Note : Link all cables before connecting electric power
9