DMT 40169, User Manual

Page: 18 / 20

16
Symptom Solution(s) Applies to
Lights Foggers &
Snow
Controller
s
Dimmers &
Chasers
Auto shut off Check fan thermal switch reset X
Beam is very dim
or not bright
Clean optical system or replace
lamp
Check 220/110v switch for proper
setting
X
Breaker/Fuse
keeps blowing
Check total load placed on
device
X
Chase is too slow Check user manual for speed
adjustment
X X X
Device has no
power
Check for power on Mains.
Check device’s fuse. (internal
and/or external)
X X X
Fixture is not
responding
Check DMX Dip switch settings for
correct addressing Check DMX
cables Check polarity switch
settings
X
Fixture is on but
there is no
movement to the
audio
Make sure you have the correct
audio mode on the control
switches. If audio provided via ¼”
jack, make sure a live audio
signal exists
Adjust sound sensitivity knob
X X X
Lamps cuts off
sporadically
Possible bad lamp or fixture is
overheating.
Lamp may be at end of its life.
X
Light will not come
on after power
failure
Some discharge lamps require a
cooling off period before the
electronics in the fixture can kick
start it again, wait 5 to 10 minutes
before powering up
X
Loss of signal Use only DMX cables
Install terminator Note: Keep DMX
cables separated from power
cables or black lights.
X X X X
Moves slow Check 220/110v switch for proper
setting
X
No flash Re-install bulb, may have shifted
in shipping
X
No laser output Bounce mirror motor may have
shifted during shipping, readjust
X
No light output Check slip ring & brushes for
contact
Install bulb
Call service technician
X
Relay will not work Check reset switch
Check cable connections
X
Remote does not
work
Make sure connector is firmly
connected to device
X X
Stand alone mode All llighting fixtures featuring
stand-alone functions do not
require additional settings, simply
power the fixture and it will
automatically enter into this
mode
X