9
Multiple Media Spinners
1.
Fasten the effect light onto firm trussing (
Use a proper clamp fastened onto the Media Spinner ).
Leave at least 1 meter on all sides for air circulation.
2.
Use a 3-p XLR cable to connect the Media Spinners and other devices.
3.
Always use a safety cable.
4.
Link the units as shown in (figure 3), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
5.
Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the other
end of the mains power cord into proper electric power supply sockets, starting with the first unit. Do not
supply power before the whole system is set up and connected properly.
Multiple Media Spinners Set Up
DMX-Set up
Master/Slave Set up
Fig. 3
Note : Link all cables before connecting electric power
Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all the fixtures on a serial data link determines the number of fixtures the data link can
support.
Important: Fixtures on a serial data link must be daisy chained in one single line. To comply with the EIA-485
standard no more than 32 devices should be connected on one data link. Connecting more than 32 fixtures
on one serial data link without the use of a DMX optically-isolated splitter may result in deterioration of the
digital DMX signal.
Maximum serial data link distance: 500 meters (1640 ft.)
Maximum number of fixtures on a serial data link: 32 fixtures
Summary of Contents for 40169
Page 1: ...Media Spinner ORDERCODE 40169 ...
Page 20: ...2007 DMT ...
