DMP Electronics XTLtouch International Series, Installation Manual

Page: 13 / 20

Digital Monitoring Products | XTLtouchINT Installation Guide
10
ADDITIONAL INFORMATION
SECONDARY POWER SUPPLY
The XTLtouchINT’s 800 mAh rechargeable standby battery is used to provide
four hours of battery power when DC power is not available. The battery is
intended for back power only and should not operate the panel on a daily basis.
If the battery is low or not plugged into the battery connector, a low battery
condition is indicated by the panel. If a 24 hour standby battery is needed,
connect a 4800 mAh battery.
Replace the Battery
1. Remove the backplate from the XTLtouchINT.
2. Unplug the battery and remove it from the base.
3. Place the new battery in the same location and secure it with the included
adhesive. See Figure 9.
4. Plug in the new battery.
5. Replace the backplate.