20
SecureCom Smart Z-Wave Thermostat Installation Guide
Setting the Heating or Cooling Temperature Setpoint
To change the setpoint, press the
buttons . The screen will switch to the setpoint change
screen and show the current setpoint of the current heating or cooling mode . Adjust the setpoint
temperature up or down with the
buttons .
NOTE:
When in the Setpoint Change screen, pressing the
MODE
button will switch the setpoint
being displayed between the Heat and Cool setpoints .
Figure 21 . Accessing Setpoints
Figure 22 . Setpoint Change Screen
Automatic Setpoint Push
The cooling setpoint cannot be set below the heating setpoint . The thermostat will “push” the
heating setpoint lower if the cooling setpoint is set below the current heating setpoint . A 3
degree separation is maintained between the heating and cooling setpoints . The same is true for
raising the heating setpoint above the cooling setpoint . The thermostat will “push” the cooling
setpoint up to maintain the 3 degree separation .
MODE
FAN
74
Off
Auto
72H 80c
F
PRESS EITHER
THE
BUTTON
TO GO TO THE
SETPOINT
CHANGE SCREEN
MODE
FAN
74
Off
Auto
SETUP
F
PRESS
MODE
TO
CHANGE FROM
THE
HEAT SETPOINT
TO THE
COOL
SETPOINT
SETPOINT BEING
CHANGED
PRESS THE
BUTTONS
TO SET THE
DESIRED
SETPOINT
RAISE TEMPERATURE
LOWER TEMPERATURE
PRESSING THE
BUTTONS WILL CHANGE
THE SETPOINT 1 DEGREE.
PRESS AND HOLD THE
BUTTON TO RAMP THE
SETPOINT
PRESS
DONE
TO SET THE SETPOINT AND EXIT
BACK TO THE MAIN THERMOSTAT SCREEN OR WAIT FOR THE
SCREEN TO AUTOMATICALLY TIME OUT
