SCS-1R Installation Guide
Digital Monitoring Products
17
OperatOr’s Guide
LCD Membrane Keypad Configuration
Note:
Before configuring the SCS-1R Security Control Receiver, make sure the LCD Membrane Keypad is set to
Address 01 (one). Refer to
Keypad Options
on the next page for instructions on setting the address and mode.
Internal Speaker Operation
The LCD Membrane Keypad speaker emits standard tones for key presses and alerts.
LCD Backlighting
The LCD backlighting turns on every time a key is pressed or the speaker sounds. The backlighting dims to medium
brightness whenever the speaker is on.
Display Options
The LCD Membrane Keypad provides three keypad adjustments you can make to suit your environment.
To access the
Display Options
portion of the keypad, press and hold the Back Arrow and COMMAND keys for two
seconds. The keypad display changes to
SET BRIGHTNESS
. Use the COMMAND key to display the next Option or
press the Back Arrow key to exit the
Display Options
function.
SET BRIGHTNESS
<
>
Brightness
Set the keypad LCD Display brightness level and the AC Power LED. Use the left Select
key to lower the keypad brightness and the right Select key to raise the brightness.
Note
: If the brightness level is lowered, it reverts to maximum intensity whenever a
key is pressed. If no keys are pressed, and the speaker has not sounded for 30 seconds,
the user-selected brightness level restores.
SET TONE
<
>
Speaker Tone
Set the keypad internal speaker tone. At the SET TONE display, use the left Select key
to lower the tone and the right Select key to raise the tone.
SET VOLUME LEVEL
<
>
Volume Level
Set the keypad internal speaker volume level for key presses and entry delay tone
conditions. During alarm and trouble conditions, the volume is always at maximum
level. Use the left Select key to decrease the keypad volume and the right Select key
to increase the volume. Press the COMMAND key to display the Model Number.
MODEL NUMBER
V200 071603
Model Number
The LCD displays the keypad firmware version and date. The user cannot change this
information in User Options.
KEyPAD ADDRESS
01
Keypad Address
The LCD displays the current keypad address. While in User Options, the user cannot
change the keypad address. Press the Back Arrow key to exit the User Options function.
Keypad Options and Diagnostics
The SCS-LCD also contains
Options
and
Diagnostic
programs that allow you to configure and test keypad
operation.
You can only access
Keypad Options
and
Diagnostics
through the Display Options. After holding down the Back
Arrow and COMMAND keys for two seconds to display
SET BRIGHTNESS
, enter the code 3577 (INST) and press the
COMMAND key. The display changes to
KPD OPT
(keypad options)
KPD DIAG
(keypad diagnostics) and
STOP
.
