DMP Electronics ITI 738I, Installation And Programming Manual

Page: 17 / 24

Digital Monitoring Products, Inc. | 738I ITI™ Installation and Programming Guide 13
Transmit Now
This is the transmitter learn function and the message
displays until the learn function completes. You must trip
the transmitter tamper by removing the cover. This sends a
transmitter identification to the 738I, identifying the device.
The 738I stores the identification and learns the transmitter.
Already Zone
Indicates that the transmitter has previously been learned as a
zone. This message continuously displays until the Back Arrow
or CMD key is pressed. When the Back Arrow key is pressed,
programming returns to TRANSMIT NOW to allow a different
transmitter to be learned. When the CMD key is pressed,
programming returns to ZONE number. (xx = zone number)
External Contact
Select the type of external contact the transmitter is using.
Press the Select key under NC for a Normally Closed circuit.
Press the Select key under NO for a Normally Open circuit.
Press the Select key under UN if an external contact is not
used on this transmitter. An asterisk appears next to the
currently selected option.
TRANSMIT NOW
ALREADY ZONE XX
EXT *UN NC NO