DMP Electronics EBOX-ALN3350, User Manual

Page: 3 / 43

EBOX-ALN3350 User Manual
DMP Electronics Inc. 3
Regulatory
FCC Class A Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Testing was done with shielded cables. Therefore, in order to comply with the FCC regulations, you must use
shielded cables with your installation.
WARNING
This product complies with EN55022 class A. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out
in the interference - causing equipment standard entitled “Digital Apparatus”, ICES-003 of the Department of
Communications.
Manufacturer’s Declaration of Conformity
This equipment has been tested and found to comply with the requirements of European Community Council
Directives 89/336/EEC & 73/23/EEC relating to electromagnetic compatibility and product safety respectively.
Attention
This product has been designed and certified to comply with certain regulatory requirements pertaining to
Information Technology Equipment. This product has not been designed for use as a medical device. Without
limitation of the foregoing, this product is not intended and has not been certified for use in a hospital or clinical
environment to diagnose, treat, or monitor patients under medical supervision, and is not intended and has not
been certified to make physical or electrical contact with patients, nor to transfer energy to or from patients
and/or to detect such energy transfer to or from patients.