DMP Electronics CELLCOMSL SERIES, Programming Manual

Page: 11 / 36

CellComSL Series Communicator Install/Programming Guide
Digital Monitoring Products
5
APPLICATIONS
Applications
The CellComSL Series Communicator is used in only one of the three applications:
3.1 Dialer Connection
Connect the two middle wires of the phone line from the control panel and connect to the CellComSL Series
Cellular Communicator to capture Contact ID messages from the burglary control panel and send the message to a
DMP Model SCS-1R or SCS-VR Receiver. Only Outputs can be used in combination with this application (See Figure
13).
3.2 Zones 1 - 3 and Outputs
Wired intrusion devices such as door contacts, tamper switches, panic buttons and PIRs can be wired to Z1 through
Z3 for zone sensing supervision. Connect wires from the CellComSL Outputs (O1 and O2) to the burglary control
panel zones. (See 1.1 Terminals > Zones for more information and Figure 14 for wiring details).
Use 18-22 AWG for
Power Supply connection
Z3
+ Z4
+ Z4
- GN
D OUT1 OUT2 CON
TROL PA
NEL TIP
CON
TROL PA
NEL RIN
G
12 VDC Aux. Output +
-
Ground
Burglary Panel
The panel or separate power
supply must be 12 Volt Regulated
and Power Limited.
Telephone
Jack
Connector
Z1
+ Z2
+
BELL -
BELL +
Input Zone 2 +
Input Zone 2 -
Input Zone 1 +
Input Zone 1 -
RESET
S1
LOAD
S2
B
AT
MODEL CellCom
PROG
S N
+12 G Z1 Z2 Z4- Z4+ G Z3 R T O2 O1
R B
†
{
Normally Open
Common
Normally Closed
Normally Open
Common
Normally Closed
†
{
Normally Open
Common
Normally Closed
†
{
J8
J26
J9
S1
S2
S3
Figure 13: CellComSL Series Wiring Diagram for Tip and Ring Connection
Use 18-22 AWG for
Power Supply connection
Z3
+ Z4
+ Z4
- GN
D OUT1 OUT2 CON
TROL PA
NEL TIP
CON
TROL PA
NEL RIN
G
12 VDC Aux. Output
+
-
Ground
Burglary Panel
The panel or separate power
supply must be 12 Volt Regulated
and Power Limited.
Telephone
Jack
Connector
Z1
+ Z2
+
BELL -
BELL +
Input Zone 2 +
Input Zone 2 -
Input Zone 1 +
Input Zone 1 -
RESET
S1
LOAD
S2
B
AT
MODEL CellCom
PROG
S N
+12 G Z1 Z2 Z4- Z4+ G Z3 R T O2 O1
R B
†
{
Normally Open
Common
Normally Closed
Normally Open
Common
Normally Closed
†
{
Normally Open
Common
Normally Closed
†
{
J8
J26
J9
S1
S2
S3
Wired Door
Contact
Figure 14: CellComSL Series Wiring Diagram for Zones 1 - 3 and Outputs.