DMP Electronics 736P Radionics, Installation And Programming Manual

Page: 9 / 40

Digital Monitoring Products, Inc. | 736P Installation and Programming Guide 5
Wire the Module
Use 18 to 22 gauge wire to connect the 736P directly to the Keypad Bus or use a
dual‑ended 4‑wire harness to connect directly to the LX‑Bus. This connection allows
the module to communicate with the panel and receive 12 VDC power. For more
information about wiring, refer to Wiring Specifications. Refer to Figure 4 when
wiring the 736P.
Connect to the Keypad Bus
1. Place a jumper across the bottom two LX/KEY pins.
2. Connect a 4‑wire harness to the 736P DMP BUS header.
3. At the panel, connect the wires to the corresponding Keypad Bus terminals.
Connect to the LX‑Bus
1. Place a jumper across the top two LX/KEY pins.
2. Connect one end of a 4‑wire harness to the 736P DMP BUS header.
3. At the panel, connect the other end of the 4‑wire harness to the LX‑Bus.
2