DMC UniDriv, Owner'S Manual

Page: 38 / 86

38
Harness Installation UniDriv
Section 9 Harness Option Installation continued
Rotary Contactor
Connect white wire to wire #5. Connect yellow wire to wire #7. Connect red wire to wire #6.
Connect green wire to wire #8. Use wire nuts. See rotary wiring detail Figures 9-5, 9-6, and
9-7.
Single Phase
Connect one large black wire to wires #2 and #4. Connect other large black wire and 16
gauge black wire to wires #1 and #3. Use wire nuts or split bolts. See rotary wiring detail
Figure 9-5.
Three Phase
Connect three large black wires to wires #2, #4, and #1 respectively. Connect 16 gauge
black wire to wire #3. Use wire nuts or split bolts. See rotary wiring detail Figure 9-6.
Middle Junction Box
Connect black wire to black wire in 16-2 cable. Connect new black wire to white wire in 16-
2 cable. Use wire nuts. See Figure 9-4. Run this new black wire along with the white, yellow
and red wires to the outside junction box.
Outside Junction box
1. Put solid state timer and capacitor in outside junction box. See Figure 9-3.
2. Connect black wire to fuse holder using blue spade connector. Attach new black wire
from other fuse holder terminal to capacitor using blue spade connectors. Connect
red wire and black wire in 16-2 cable (inside micro-switch) to timer terminal 1 using
yellow spade connector. Connect yellow wire and black wire in 16-2 cable (outside
micro-switch) to timer terminal 3 using yellow spade connector. Connect white wires
from both 16-2 cables together using wire nut.
3. Connect white wire to the white and red wires from the gearmotor using wire nut.
Connect black wire from gearmotor to capacitor. Put this on the same terminal set as
the black wire coming from the fuse holder. Connect blue wire from gearmotor to
other terminal set on capacitor.