RLS PEND inputs should interface with isolated contacts or logic circuits
to avoid ground loops between equipment.
6. Run the CAT5e data cable to the desired locations with the ferrite RF
suppressor at the Interface Module end. Connect the RJ45 modular
connectors to the Interface Module.
7. Install the Ultimate Remote Control at its desired location, connect the line
out connection (if desired) and connect the power supply. The backlight
will come on, the strobe may flash once and “DM Engineering” along with
the software version number will momentarily be displayed. Now connect
the CAT5e data cable.
8. Re-apply power to the Sage-Endec and wait for the self diagnostics and
start-up function to complete. The LCD sign on the Ultimate will display
zeros or remain blank until the next minute advance of the Sage-Endec
clock and then will display the date and time.
9.
The User password must be 1111
, the factory default password.
There can be no exceptions without custom programming of the Ultimate
microprocessor. Custom programming is available at an additional
charge. Please contact DME if custom programming is desired.
10. To change the User password to 1111, use the
menu.change password
command on the Endec. You will need the administrator’s password to
do this change, and if it is not available consult section 14.3 of the
SE1822 Endec User Guide or section 12.11 in the 3644 Digital Endec
User Guide.
11. Assure that the “Decoder Active” or “Dec Rly” relay is set to either the
default “Pending” or to the “Pending Done” (preferred) relay program. Go
to
menu.relay
, and scroll to the “Decoder Active” relay, and press
pick.
Then scroll to the “Pending Done” or “Pending” choice and select it. See
table 5-7 and section 5.7.2 of the SE1822 Sage-Endec User Guide or
Table 3-2 and sections 4.7 and 5.7 or the Digital 3644 User Guide for
assistance.
Operational Testing note:
It is advised that you remove the Sage-Endec from the
audio chain before proceeding to avoid on air transmissions from the unit. Just
connect the XLR audio inputs to the XLR outputs temporarily.
After the LCD sign is displaying date and time you are ready to test the equipment.
Remember…if you have the Sage-Endec in the audio chain it will broadcast alerts!
Try an RWT from the Ultimate Remote Control. The red “Sending Data” LED will
light and then the LCD sign will display that the station has sent an RWT and the
strobe will flash green. The Sage-Endec will output an RWT. Clear the sign on the
Ultimate Remote Control only after the red “Sending Data” LED goes out.
7
