/ / / / / /
DEPLOYEDLOGIX.COM // @DEPLOYEDLOGIX // EMAIL: [email protected] // P: 541.357.5978
©️ 2021 DLX ENTERPRISES LLC. // VERSION 1.02
//
17
Turn the material over so that the adhesive side of the tab is facing up.
Position reinforcement filament tightly against the outside edge. The filament
should be perpendicular to the open end of the tear to create a tough solid
edge.
Fold over the patch’s 1 inch tab and rub to adhere to the back side of the
material.
Apply another patch to the back side of the patched tear (so that both sides of
material are patched). Rub the entire patch aggressively.
4.
5.
6.
7.
Tear on Edge
Fold 1 inch Tab Over Filament
Apply Leaving 1 inch Tab Beyond Edge
Apply Reinforcement Filament
Apply to Back Side
Cut Filament to Width of Patch
NOTE: Heating is an option and normally not needed unless temperatures are below freezing.
1.
2.
3.
Cut patch 1 inch beyond all edges of the tear. If using more than one patch,
overlap at least 1 inch. Trim and round corners.
Peel back 1/2 inch of paper liner.
Position exposed edge - allowing the patch to extend 1 inch beyond all edges
of the tear. Peel back the liner while applying the patch over tear. Follow
steps 1-3 on the back side of the repair if you have access to the back side.
Follow steps 1-3 with the following adjustments:
• Cut the patch size to extend a full 1 inch beyond the edge of the torn material.
• Peel and stick, positioning the patch with a 1 inch tab beyond the outside edge
of the torn material.
// REPAIRING GENERAL TEARS AND HOLES //
// REPAIRING TEARS EXTENDING THROUGH AN OUTSIDE EDGE //
DRAIN INSTALLATION
DRAIN PUMP INSTALLATION
TEAR-AID APPLICATION
TEAR-AID APPLICATION
!
!
Summary of Contents for ASAP-HUB
Page 19: ...18 ...
