DKS PD96, User Manual, Page: 28 / 57

User manual for meter with U/I input PD96
28
7.2.1. Numeric parameters (digit change mode)
Numerical parameters are displayed as decimal numbers. The mode of its new value
entering depends on chosen edit method (
see parameter „
Edit
”).
In mode “by digit” („
Edit
”=”
dig
”) pressing one of the keys
[^] or [v] causes change of
current position (flashing digit) or the sign (+/-). Short pressing of the [ENTER] button
causes change of the position (digit).
Press
[ENTER] at least 2 seconds to accept the changes, after that question
”SEt?”
is
displayed, and user must to confirm (or cancel) the changes. To conform changes (and
story it in EEPROM) press
[ENTER] button shortly after
”SEt?”
is displayed. To cancel
the changes press [ESC] button shortly after
”SEt?”
is displayed. After that device
returns to the menu.
7.2.2. Numeric parameters (slide change mode)
In
“slide change” mode („
Edit
”=”
Slid
”), buttons
[^] and [v] has different functions.
To increase edited value press (or press and hold) [^] button only, the increasing
became quickest as long as button [^] is pressed. To slow down the increasing, button
[v] can be used. If [v] is pressed shortly (and button [^] is still pressed), increasing
slow down for a moment only, if [v] is pressed and held while button [^] is still pressed
the increasing slow down and will be kept on lower speed.
To decrease edited value press (or press and hold )
[v] button only. The decreasing
became quickest as long as button [v] is pressed. To slow down the decreasing,
button [^] can be used. If [^] is pressed shortly (and button [v] is still pressed),
decreasing slow down for a moment only, if [^] is pressed and held while button [v] is
still pressed the decreasing slow down and will be kept on lower speed.
Press
[ENTER] at least 2 seconds to accept the changes, after that question
”Set?” is
displayed, and user must to confirm (or cancel) the changes. To conform changes (and
story it in EEPROM) press
[ENTER] button shortly after
”SEt?”
is displayed. To cancel
the changes press [ESC] button shortly after
”SEt?”
is displayed. After that device
returns to the menu.
7.2.3. Switch parameters
(“LIST” type)
Switch parameters can be described as a sets of values (a lists) out of which only one
of the options available on the list can be selected for the given parameter. Options of
switching parameter are selected using
[^] , [v] keys.
Short pressing of [ENTER] causes in displaying of the acknowledge question (
”SEt?”
).
If key [ENTER] is pressed again, the changes are accepted, stored in EEPROM end the
edition process finished. Pressing the key [ESC] after
”SEt?”
causes in cancelling of
made changes and returning to menu.