Room thermostat DK LOGIC 100
13
12. CLO mode - setting the current hour and day
1.
Press the button for a few times till CLO
symbol appears on the screen. Confirm by
pressing .
t
2.
An indication of hour is blinking on a screen -
this can be set by using the “-/+” buttons and
confirmed by pressing . Next, following the
same steps, the minutes can be set and
confirmed by pressing .
t
t
3.
An indication of a day of the week is blinking on
a screen - this can be set by using the “-/+”
buttons (d:1 - Monday; d:2 - Tuesday, etc.) and
confirm by pressing - after a while, the
controller will switch to the main screen view.
13. PAr1 mode - a parameter visible on a main screen
PAr1
- selection of parameter displayed on the screen during operation of the
thermostat (hour / temperature).
1.
Press the button for a few times till Par1
appears on the screen. Confirm by pressing
.
t
14. PAr2 mode - program version and RESET
PAr2
- shows the program version installed in the controller. Additionally, in this
mode, it is possible to reset all the settings of the thermostat.
2.
One of the following symbols will appear on the
screen: C - means that the time will be seen on
a main screen; t - means that the temperature
will be seen on a main screen. Choose the
required option by pressing the “-/+” buttons
and by confirming with after a while, the
controller will switch to the main screen view.
