DK Digital CDB-650, Owner'S Manual

Page: 6 / 12

Power supply
You can operate this device with the mains voltage of AC230V~ / 50 Hz, or with battery
power.
Mains operation
Connect the mains cord to a properly wired wall outlet with a voltage of AC230V~ / 50 Hz
and to the mains socket on the rear panel of the unit. Now the device is operational.
Battery operation
Open the battery compartment on the bottom side of the unit. Insert 6 x 1.5V UM-1 "D" size
batteries (not supplied) into the compartment according to the insertion instructions in the
battery compartment. Observe the correct polarity of the batteries, as otherwise the device
may suffer damage. Due to their longer service life, we recommend you to use alkaline
batteries. Close the compartment again. Now the device is operational.
Batteries must not be thrown in the household waste. Please take used
batteries to the respective collecting points or take them there where
you have bought the new ones. Do not throw batteries into the fire.
General operation
Move the FUNCTION switch to choose the desired function.
Ø
"CD/MP3" for CD/MP3 playback, or
Ø
"RADIO" for radio reception, or
Ø
"TAPE" for cassette operation.
To switch the unit off, move the FUNCTION switch to the "TAPE" position.
With the VOLUME controller you can set the volume as requested. Turn the controller
clockwise to increase the volume. Turn it counter clockwise to lower the volume.
Headphone Operation
You can connect a headphone to the PHONES jack at the rear end in the device using a
3.5mm jack plug. This deactivates the build-in speakers.
X-BASS
If you would like to boost the low frequencies, press the X-BASS button. Press the button
again to deactivate this function.
Be careful with regard to your hearing. A too high volume may lastingly impair the
hearing ability of your ears.
6