One power cord
One user manual
Operation
Place the machine on a firm and level surface where it will be used. Take off the
lid and fill with about 5 gallons(18 liters) water(hot or cold). Connect the unit to
power, when the red light is on, it means the machine is heating up.
Plug the cord into a grounded 22-amp receptacle. The heater draws 11 amps at
230 volts.
While the machine is heating up, raise the built-in basket to its highest level
and fasten it with the black handle on the side of the machine.
After steaming the water for approximately 30-50 minutes, the machine will be
ready to use.
Using protective gear load, the basket can hold 8 kilograms (about 18 lbs) of
dry ice. Please Note: Usually the dry ice being used here cover 2/3 of the whole
basket. Put into the dry ice at the last possible moment when needed, because
the steamy atmosphere in the machine will make the dry ice inside evaporate if
it is put inside too long beforehand.
After holding the dry ice, tighten the lid, and screw the lid latch according to the
instruction of imprint.
When the fog is in need, grasp the operation lever and slowly lower the handle.
A full basket should not be plunged into the hot water completely, because the
violent dry-ice sublimating would result in high and dangerous pressure in the
housing . The operation lever is used to allow the basket to move up and down
in the water. As the solid CO is immersed, thick cloud-like fog will be produced
2
from the nozzle. To increase the rate, lower the lever to the end. Fully raising
the handle will quickly stop the fog output. Thus it is possible to realize the
“ON” and “OFF” control by adjusting the operation lever.
When the machine is to be emptied, allow it to cool. Empty the remaining water
in the machine to buckets where the machine stands rather than carrying it to
drain. Do not move the machine with hot or boiling water in.
Maintainance
Keeping lid latch slightly oiled will protect them and allow them to operate
easily.
Make sure no other barriers in the rubber lid seal, otherwise it will allow gas
escape through the lid gasket.
When you heat up the machine, leave the lid off. This prevents the carry
handles from getting hot before adding dry ice.
Do not pour cold water directly onto hot heating element as this will cause
03
3.
4.
5.
6.
7.
2.
3.
8.
1.
2.
3.
4.
1.
2.
