djm direct DJMSS406, Operating Manual

Page: 10 / 18

Lighting System (For #65115B)
Press "I" to turn on the lamp.
Press "O" to turn off the lamp
This light switch can only work when the ON/
OFF switch for the product is turned on
13. Maintenance
General
Wipe chips and dust off the machine from time to
time using a cloth.
Re-application of the wax coating on the
workbench makes feeding the workpiece to the
blade easier.
The mains cable should be replaced immediately
if pulled out, cut or damaged in any other way.
Do not lubricate the motor bearings or internal
parts!
Changing the Saw Blade with pins
1. Saw blade removal. Extract the saw-blade by
unscrewing the Clamping screw. Remove the saw-
blade from the upper and lower support by slightly
pressing the upper arm down.
2. Inserting the new saw-blade. Lead one end of the
saw-blade through the perforation in the table and
insert the saw-blade pins into the notch. Repeat this
procedure at the upper blade support. Before hooking
it in. Slightly press the upper arm down. Check the
position of the blade pins at the supports. Tighten
the blade by means of the Clamping screw. Check the
blade's tightness. Keep on rotating clockwise in order
to tighten the blade even more.
9
Warning! In the interests of
operational safety, always switch off
the saw and remove the mains plug
before carrying out maintenance
work.
Switch off the saw and remove the
mains supply plug before installing
saw blades in order to avoid injuries
caused by unintentional activation of
the saw.