©
2016 DJI. All Rights Reserved.
Allow Camera Underslung
Tap to allow the camera mounted invert on the gimbal.
Motor Kill
When the motor kill switch is activated, the Ronin-MX is still powered on, but the motors will be
powered off. This will allow an adjustment to the gimbal or camera without having to turn it off
completely. Prior to turning off the Motor Kill Switch, make sure the gimbal is positioned in the
standard operating position.
Calibration
Place the aircraft in a steady flat before perform the calibration. The Ronin-MX will be power off
and power on again automatically when calibration is complete. Observe the roll axis’s position,
recalibrate is needed if the roll axis is off level.
Ensure there is nothing obstructing the gimbal’s movements during calibration.
Balance Detection
Tap to check the balance status of the tilt and roll axis. Ensure there is nothing obstructing the
gimbal’s movements.
Default Settings
Tap to restore all the gimbal settings to the default settings.
Remote Controller Operation
The Ronin-MX only can be controlled by the Matrice 600’s remote controller instead of the remote
control of Ronin-MX.
Adjust the Ronin-MX’s tilt or pan by using the gimbal dial on the remote controller. (Configure
through the C1 and C2 buttons according to the DJI GO’s tips.)
