©
2016 DJI. All Rights Reserved.
When adjusting the roll balance position of the camera, only loosen the two lock-knobs a
few turns to allow the camera base to slide. Do not loosen the lock-knobs excessively.
Step 3
:
Balancing the Tilt Axis
1.
Loosen the camera base's side clamp and the lock-knob on the cross bar to allow the camera
and mounting plate to slide forwards and backwards.
2.
Slide the camera forwards or backwards until the tilt axis remains level. Only very small
adjustments are required to achieve the proper balance.
3.
Tighten the side clamp to lock the camera and mounting plate in position. When the proper
fore and aft tilt balance is achieved, the camera will stay level when you remove your hand
(while holding the roll axis in position).
Step 4: Balancing the Pan Axis
To achieve the pan axis balance, you must adjust the pan axis slide.
1.
Open the clamp [1] on the pan axis and turn the knob [2] to slide the assembly. Identify if the
Ronin-MX is front heavy or rear heavy. Rotate the Ronin-MX on the stand so one side is higher
than the other, if the front end rotates from the higher position to the lower position and that
means the Ronin-MX is currently front heavy, then you will need to slide the gimbal backward,
otherwise you need to slide the gimbal forward.
2.
Tighten the clamp after balancing is completed. While the Ronin-MX is resting on the tuning
stand, try rotating the Ronin-MX. If the camera does not swing, the pan axis is properly
balanced.
