dji MG-12000P, User Manual

Page: 5 / 27

4
• Never use or charge swollen, leaky, or damaged batteries. If your battery is abnormal,
contact an authorized dealer for further assistance.
• The battery should normally be used in the temperature range 41° to 113° F (5° to 45° C).
Use of the battery in environments above 122° F (50° C) can lead to fire or explosion. Use
of the battery in temperatures below 32° F (0° C) can lead to a sharp decrease in flight
time. (If using the battery in the temperature range 23° F to 41° F (-5° to 5° C) it must first
be ensured that the battery voltage is at its maximum. In this temperature range the aircraft
should be flown with no load.)
• DO NOT use the battery in strong electrostatic or electromagnetic environments or near
high-voltage transmission lines otherwise the battery control board may malfunction and
cause a serious accident during flight.
• Never disassemble or pierce the battery in any way or it may leak, catch fire, or explode.
• Batteries that fall off are very dangerous. DO NOT use such batteries and dispose of them
as described in the Battery Disposal section.
• DO NOT put the battery in a microwave oven or in a pressurized container.
• DO NOT drop, strike, impale, or manually short-circuit the battery.
• DO NOT place heavy objects on the battery.
• Always hold the bar instead of the cables or the rubber belt when lifting the battery.
• Ensure the battery is fully charged before each flight.
• Immediately land the aircraft if a critical battery level warning appears and replace the
battery with a fully charged one.
• When operating in low temperature environments, before using the battery first leave it in
a room temperature environment and allow it to gently warm to above 41° F (5° C) (ideally
above 68 ° F (20° C)).
• Cover the ports with the rubber covers when the battery is not in use to protect the ports
from moisture and dirt, which could lead to corrosion or other issues.
LED Patterns
Battery Level LED Patterns
LED is on
LED is flashing
LED is off
If the battery is in power saving mode press the Battery Level Indicator button once to check
current battery level. (Note: If a battery exception has occurred, when the Battery Level Indicator
is pressed the LEDs indicate which exception has occurred. Refer to the Battery Exception LED
Patterns section for further information.)
LED1 LED2 LED3 LED4 Battery Level
88%~100%
75%~87%
63%~74%
50%~62%
38%~49%