Dixie Narco FLEXPAK 3000 DMV 72N, Programming/Set-Up/Configuration/Troubleshooting/Operation/Parts Manual

Page: 6 / 61

6
Ground The Vender
The FlexPak

3000 is equipped with a three wire power supply cord and MUST be plugged into a properly
grounded outlet.
DO NOT REMOVE THE GROUND PIN OR IN ANY WAY BYPASS THE GROUNDING OF THE
FLEXPAK
 
3000. If the outlet will not accept the power cord plug, contact an electrician to install a proper
AC outlet.
WARNING: Failure to comply with these instructions may subject the user to the risk of
injury or electrical shock which can be serious or fatal.
Placing The Vender On Location
CAUTION: DO NOT TRANSPORT THE VENDER TO OR FROM THE LOCATION WHEN IT IS
LOADED WITH PRODUCT; DAMAGE TO THE VENDER MAY RESULT.
The vender must be located on a solid, flat, and level surface.
The vender must be positioned close enough to an electrical outlet that an extension cord is not required. If
securing the vender to the floor or wall is required, call the Dixie-Narco Factory Service Department for
suggestions.
Level The Vender
Level the vender. When the vender is level, the door can be opened to any position and it will not move by itself.
Open the door to several different positions before deciding that the vender is level. Make sure that all of the
leveling legs are in contact with the floor. If you cannot level the vender, select another location. Do not place
any objects under the machine.
DANGER: THE VENDER MUST BE PROPERLY LOCATED AND LEVELED TO MINIMIZE
THE RISK OF INJURY OR DEATH FROM TIPPING IN THE EVENT OF MISUSE OR
VANDALISM.
Space The Vender
Do not block the rear of the vender. Maintain a minimum of 10 cm (4 in) from the wall to insure adequate air
flow to the condenser and compressor. At the front of the vender, make sure that nothing obstructs the air
intake at the bottom of the main door. At the rear of the vender, make sure that nothing obstructs the air exhaust
at the bottom of the cabinet.
Installing Flavor Cards
The flavor cards are inserted in the selection buttons. On non-TBV machines, swing the coin changer mounting
plate away from the outer door exposing the back of the select buttons. The flavor cards are inserted in the back
of the selection buttons from either side or remove the flavor card carrier. Ensure the flavor cards are placed in
the select button flavor card carrier position that corresponds to the module in which the product is loaded.
Install the flavor card carrier back in position. In TBV machines, carefully remove the select button lens from the
select button. Insert the flavor card in the lens. Snap the lens back in position in the select button. Ensure the
flavor cards are placed in the select buttons that correspond to the module in which the product is loaded.