Thank you for the purchase of this DiversiTech condensate pump. This
pump is designed to automatically remove the condensate water that
collects from appliances such as air conditioners, high-efficiency furnaces
and de-humidifiers.
The pump has a built-in tank that collects the water from the appliance.
When the water collected reaches sufficient level inside the pump tank,
the pump switches on and pumps the water to a remote location for
disposal. When the tank is sufficiently empty the pump automatically
switches off.
The pump is capable of lifting water to its rated height and is equipped
with a check valve that prevents water from flowing back into the tank
when the pump shuts off.
The pump is outfitted with lights that show the status of power available,
motor running and high water (alarm) conditions.
The pump is also equipped with a switch that activates when the water in
the tank reaches an overflow condition. The overflow safety switch may
be connected to turn off the appliance if the high water condition occurs.
The switch also has an alarm terminal that may optionally be connected to
an audible alarm or remote indicator light to indicate a trouble condition.
Pump should be stored indoors.
The chosen location should be clean and dry.
Carefully open the carton to avoid damage to the pump. Do not use a
knife or other sharp object that may scratch the pump’s cover. After
opening the carton, look for damage. If damage is found file a claim with
the freight carrier.
CAUTION: Be sure to remove the cardboard insert. It is used to protect the
float during shipment. Failure to remove the insert will cause the pump to
run continuously.
Supply voltage and frequency must match what is shown on the pump
nameplate. Source voltages lower than the rated supply can reduce
performance and cause the pump to overheat.
The pump must be level and should be placed on a solid surface or floor.
The pump has rubber feet to reduce noise and keep it in place during
operation.
Do not use this pump in the presence of spraying or standing water, it may
cause a shock. This pump is not suitable for use in Class I or Class II loca-
tions (explosive gas or dust).
Do not cover the pump air vents. The pump is air cooled. Do not cover
the vent holes located on the top or sides of the pump housing. The pump
may be operated continuously as long as the air vents are not covered.
General Information
Unpacking
Power Source
Pump Installation
CHECK FOR
SHIPMENT
DAMAGE
