ASSEMBLY TEMPLATE
NOTE:
1.
ALL WATER, ELECTRICAL, AND GAS CONNECTIONS SHOULD BE
PERFORMED BY A TRAINED PROFESSIONAL PER LOCAL CODE.
REVISION LEVEL
EMK
11/8/16
CREATED DRAWING
REV.
A
-
DWN
TITLE:
BY:
BY:
APR
DATE:
DWN
APR:
DATE
REVISION:
SCALE:
SHEET:
DRAWING NUMBER:
300 South Krueger Street
Suring, WI 54174
diversifiedwoodcrafts.com
THIS DRAWING IS THE SOLE PROPERTY OF
DIVERSIFIED WOOD CRAFTS. IT MAY NOT
BE ALTERED OR CHANGED WITHOUT
PERMISSION
BY:
APR
APR:
DATE
FORWARD VISION III
FORWARD VISION III
ASSEMBLY INSTRUCTIONS
REV A
6 OF 7
NTS
EMK
11/8/16
NAME
DATE
DESCRIPTION
ECN NO.
UNLESS OTHERWISE SPECIFIED
DIMENSION ARE IN INCHES
STEP 7:
ADJUST LEG LEVELERS TO LEVEL THE WORKSTATION FRAME WITH
CABINETS. APPLY SILICONE ADHESIVE TO TOP EDGES OF CABINET AND
WINGS. PLACE TOP ON UNIT WITH PROPER OVERHANG (CENTERED ON
WORKSTATION). CLAMP ON TOP TO WINGS TO REMOVE ANY WARP
USING SHIMS AND C-CLAMPS, IF NEEDED, WHEN ALIGNING THE TOP
(DO THIS BEFORE ADHESIVE ON EDGES SETS UP). LET CURE FOR 6-12
HOURS. DO NOT APPLY SILICONE ADHESIVE TO REMOVABLE PANEL .
STEP 8:
IF YOU DO NOT HAVE A "K" SERIES UNIT, SKIP TO STEP 9. APPLY SILICONE
ADHESIVE TO THE SINK OPENING ON TOP. LOWER SINK INTO OPENING.
WIPE OFF ANY EXCESS CAULK AND ALLOW TO SET. LET CURE FOR 6-12
HOURS.
APPLY SILICONE ADHESIVE
TO TOP EDGES OF WINGS
AND CABINETS
TOP
APPLY SILICONE ADHESIVE
HERE FOR SINK
TOP VIEW OF WORKSTATION SHOWN
TOP VIEW OF WORKSTATION SHOWN
DO NOT APPLY SILICONE ADHESIVE
TO REMOVABLE PANEL
STEP 9:
ATTACH RUBBER MOLDING TO BASE OF WORKSTATION USING CONTACT
CEMENT. AFTER MOLDING IS IN PLACE, SCREW STAINLESS STEEL CORNER
BRACKETS ON EACH CORNER OVER BASE MOLDING WITH THE SCREWS
PROVIDED. IF YOU HAVE A "K" SERIES UNIT, INSTALL MULTI-SERVICE
FIXTURES IN THE HOLES PROVIDED ON TOP.
COMPLETE UNIT SHOWN
APPLY RUBBER
MOLDING HERE
MULTI-SERVICE
FIXTURES
K:\DIVERSIFIED\ASSEMBLY INSTRUCTIONS\ACAD\2924K & KF, 2926K & KF, 2964K & KF,
2966K & KF SERIES.dwg, 12/2/2016 11:38:51 AM, DWG To PDF.pc3