DITEC TRAFFIC C, Installation Manual, Maintenance, Use

Page: 48 / 52

- 48 -
0DT829 2016-04-01
Part Part number
Cycles / hour
Abusive
Environment
(1)
<10
Low Traffic
<30
Medium Traffic
>30
High Traffic
Months Months Months
Limit switch group (if 400V) 6K10GF
36 24 12 12
Limit switch (if 400V) 5M 48 36 24 24
Brake disc 21572
36 24 12 12
Brake disc guide 21571
36 24 12 12
Safety edge coiled cable 27795B
36 24 12 12
Belt counterweight and curtain 6KTFCS 36 24 12 12
(1) Dirty or dusty environment, operating temperature near to 0°C or over 35°C, wind pressure within 20% of maximum limit.
9. MAINTENANCE TO BE CARRIED OUT EVERY 6 MONTHS
Regular inspections should be made according to national regulations and product documentation by a Entrematic Group AB
trained and qualified technician. The number of service occasions should be in accordance with national requirements and
product documentation.
I
nstallation / Fitting
• Tighten the fitting screws of the uprights with the crosspiece
• Check the anchoring of the door to the door frame
Motor
• Check the fixing of the motor to the relevant support
• Check the tensioning of the transmission chain
• Check the limit switches functioning and the good alignment with the cams.
• Check the brake disc wearing. If necessary replace the disc
• Check the properly manual release lever brake functioning (when applicable)
Main Shaft / Belt
• Check the good bearing supports fixing
• Lubricate the support of the bearings by suitable grease inlet
• Check the wear and tear of the counterweight belts and the curtain. Replace the belts if necessary
Safety Devices
• Check the good safety bar functioning
• Check the good conditions of the safety bar rubber profile
• Check the adjusting and the eventual wearing of the steel cable of the electromechanical safety edge
• Check the wearing of the mobile cable
• Check the correct operation of the safety photocells
9.1 Maintenance Plan
The table below shows the recommended interval - in months - when to replace parts during preventive maintenance.