GB
11
CROSS30 - IP1777
3.3 Geared motor installation
-
Open the gear motor removable cover. Loosen the three
screws [A]
(the upper screw must not be completely
loosened)
and remove the case.
-
Remove the nuts used to fasten the anchoring brackets.
-
Position the gearmotor onto the base plate.
-
Gearmotor adjustments
Horizontally, by having it slide along the gear motor base
slot (approx. 20 mm).
Vertically, by means of the 4 level screws [B] and by insert
-
ing the provided shims [C].
Note: once the level shims have been inserted [C], loosen
the screws[B], the motor shall weigh only on the shims [C].
Note: while adjusting vertically, keep the motor slightly
raised above the base plate so as to allow enough space to
secure the rack and to make any subsequent adjustments,
if necessary.
3.4 Rack installation
Warning: use a module 6 rack.
-
Release the gearmotor and set the gate in the open po-
sition. Place the rack on pinion [14] and move the gate
manually to secure the rack along its full length.
-
Once the rack has been secured, vertically adjust the
geared motor so as to have a gap of 2 to 3 mm between
the pinion and the rack with screws [B].
Warning: the motor shall weigh only on the shims [C].
-
Firmly secure the gearmotor with the nuts [D].
-
Slightly lubricate the rack and pinion after assembly.
Manually check that the gate slides evenly and without
friction.
min
90
200
80
OPENING
X+20
65*
65*
116
54
230
400
Ø80
Ø12
TCEI-M8x16
TCEI-M8x16
A
A
A
TC-M8x20
B
B
B
D
D
D
C
C
D
min
90
200
80
OPENING
X+20
65*
65*
116
54
230
400
Ø80
Ø12
max 160
17
17
18
2÷3
