Ditch Witch XT855, Operator'S Manual

Page: 81 / 107

Service - 80
XT855 Operator’s Manual
Recommended Lubricants/Service Key
CMW
Engine Oil Temperature Chart
Approved Coolant
Any ethylene glycol based coolant is approved for use with this unit. However, it was filled with John Deere
Cool-Gard coolant before shipment from factory. Add only Cool-Gard or any fully-formulated, ethylene
glycol based, low-silicate, heavy-duty diesel engine coolant meeting ASTM specification D6210 (fully
formulated) or D4985 (low silicate). Before using any other kind of coolant, completely flush radiator.
Approved Fuel
The engine is this unit is designed to run on diesel fuel. Use only high-quality fuel meeting ASTM D975 No.
2D, EN590, or equivalent. At temperatures below 32°F (0°C), winter fuel blends are acceptable. See
engine operation manual for more information.
Biodiesel blends up to 5% (B5) are approved for use in this unit. The fuel used must meet the
specifications for diesel fuel shown above. Extra attention is needed when using biodiesel, especially when
operating in cold weather or storing fuel. Contact your Ditch Witch dealer or the engine manufacturer for
more information.
Fuel sulfur content should be less than 5000 ppm (0.5%). Worldwide, fuel sulfur regulations vary widely.
Fuel used should always comply with local regulations. Do not use lube oil meeting API CJ-4 (or other low
SAPS equivalent) if fuel sulfur content is above 5000 ppm (0.05%, low sulfur diesel in the U.S.).
NOTICE: Do not mix heavy-duty diesel engine coolant and automotive-type coolant. This will lead to
coolant breakdown and engine damage.
Temperature range anticipated before next oil change