Plow - 92
RT45 Operator’s Manual
Operation
Start Plowing
1.
Fasten and adjust seat belt.
2.
Start tractor.
3. Adjust throttle to low idle.
4.
Check that ground drive control is in neutral.
5.
Lower reel carrier to lowest position possible, if equipped.
6.
If equipped with combo, move selector valve to plow position. If equipped with backfill blade tilt/
attachment swing valve and control, move selector to swing position.
7.
Raise backfill blade.
8.
Move ground drive control forward to plowing speed and lower plow blade into ground.
9.
Increase engine speed to full throttle.
10. Move attachment speed/direction control to full speed forward. PLOW WILL VIBRATE.
11. Reduce attachment speed to allow the least tractor vibration at the highest ground drive possible
without tire slippage.
12. Check cable for damage during plowing. Run continuity checks on electric cable and check pipe
pressure. Damage can result from improper operation, incorrect blade choice, striking underground
obstructions, or other conditions.
Finish Plowing
1.
When installation is complete, move ground drive control to neutral.
2.
With vibrator running, lower throttle speed and raise plow to ground level.
3.
Move attachment speed/direction control to neutral.
4.
Engage parking brake.
5.
Lower backfill blade.
6.
Turn ignition switch to STOP and remove product from plow.
7.
Start tractor, raise backfill blade and drive a short distance away from work site.
8.
Shut down tractor. See page 72 for proper shutdown procedures.
NOTICE:
Use extreme caution when operating reel carrier on sloped surfaces.
NOTICE:
Do NOT move ground drive to reverse with plow blade in the ground.
NOTICE:
Do not operate vibrator when plow is out of the ground. This will cause excessive
vibration resulting in rapid wear, and possible damage to the unit and product being installed.
Summary of Contents for RT45
