14(33)
User manual in Original
Dok. ref: User manual 500A-BAS Rev. B
DISPERATOR AB
Tel: +46 8 724 0160
E-mail: [email protected]
Mälarvägen 9, SE-141 71 Segeltorp, Sweden Fax: +46 8 724 6070
Web page: www.disperator.se
6.
Installation Instructions
6.1.
Assembly of Disposer
6.1.1.
Installing the Disposer in an Existing Assembly
Install the disposer in the existing assembly, or in the assembly made by another supplier according to
its specification.
6.1.2.
Mounting and Support against Floor/Floor plate
Mounting of models 510A and 515A, delivered without legs as standard
The weight of disposer models 510A and 515A allows them, in most cases, to be hung vertically under
the mounting assembly (e.g. under a sink). The standard delivery of these models will therefore not
include legs. However, if they are to be placed standing on the floor / floor plate (e.g. beside a peeling
machine / dishwasher) these models must be fitted with legs. If legs have been ordered it is specified
on the delivery note.
To minimize the risk of injuries, two persons shall always be present when the disposer is installed.
Below describes three different approaches, depending on the availability of tools at the installation
site.
Place the disposer tightly against the flange of the mounting assembly, by using one of below
mentioned hoist methods; make sure that the rubber seal is correctly placed. Tighten the six screws
with nuts evenly; the rubber seal should be compressed approximately 1mm.
Hoist alternative 1
Trolley, see picture below.
