User Manual in Original
Dok. ref: 550A_GKF_am_sv_210525
DISPERATOR AB
Tel: 08-724 0160
E-mail: [email protected]
Mälarvägen 9, 141 71 Segeltorp
Web page: www.disperator.se
24 / 35
13. Remove the rotary shredder (2/02) by placing two crowbars opposite one another under the rim
of the shredder, supported by the side of the end shield (2/13).
14. Remove the V-ring seal (2/-03/01) and loosen the 4 fixing screws (2/23) of the end shield.
Note
the position of the crusher outlet on the end shield
(2/13)
relative to the motor (2/14), so this
outlet will get the same direction when reinstalling the crusher. Lift off the
end shield
.
15. Inspect the washer (1/-03/00) for possible wear caused by the V-ring seal and check that it do
not have wear grooves or scratches. Replace the washer if necessary.
16. Turn the end shield (1/13) upside down and remove the locking ring (1/-03/03) by means of
a circlip pliers. With some adequate protection in between, apply pressure to the washer (1/-
03/00) in order to get the two axle seals (1/-03/02) out. See below photos.
Again, make sure that the surface of the washer (1/-03/00) is in good condition. Also examine
the contact surface of the carrier (2/18) for wear caused by the axle seals (1/-03/02). There
should only be two small symmetrical tracks on the carrier if it has been running correctly. Are
tracks severe, asymmetrical or more than two, replace the carrier.
17. Terminate dismantling here when carrier (2/18) or motor (2/14) do not need to be replaced.
Start the reassembling from item 5 in section 9.5. below.
The V-ring seal (2/-03/01) and the two axle seals (1/-03/02) with special grease (2/04) together
with stationary seal (3/2) must be replaced at every dismantling.
18. To remove the carrier (2/18), screw down the supplied dismantling screw (see photo in section
9.7.3. below, No. -18/02) at the top of the carrier.
This pulls off the carrier from the motor axle
.
If needed, use the rotary shredder (2/02)
as a handle to prevent rotation of the motor axle.
Alternatively, hold the carrier with a pliers and soft cloth in between as shown in the photo
below.
Summary of Contents for EXCELLENT 550A-GKF Series
Page 2: ......
