![background image](http://html1.mh-extra.com/html/dish-network/satellite-television/satellite-television_user-manual_2509124064.webp)
Receiver Customization
53
Improving Receiver Control
1
Press SYSTEM INFO on the receiver's front panel. The System Info screen displays on
the TV and shows the Remote Address.
Write down the Remote Address:
2
Press and hold SAT on your remote control for about three seconds, until all of the Mode
buttons light up, and then release SAT.
3
Use the NUMBER PAD to enter any number between 1 and 16, but not the one you wrote
in step 1.
4
Press POUND (#). If you entered the address correctly, SAT flashes three times.
Write down the number you entered:
5
Press RECORD. Make sure the Remote Address you see on the System Info screen is
the same as the one you entered in step 3. If it isn't, the remote cannot control the
receiver.
6
Press SELECT to close the System Info screen.
Checking the Remote Control Address
1
Press and hold SAT for three seconds, until all of the Mode buttons light up, and then
release SAT.
2
Press POUND (#) twice. The SAT mode button flashes the same number of times as the
address number (for example, three flashes means address 3).
Summary of Contents for Satellite Television
