7
2 Following the polarity diagram shown in the battery
compartment, insert 3 'AA' (UM-3) batteries (Not included)
and close the battery door.
3 Open the Connector Rubber Dust Cover, set the Charger
IN/OUT Switch to IN position.
4 When batteries were installed, the power of the build-in
rechargeable battery pack will be cut off after setting the
Power Source Selector to “BATT./DC” (DRY CELL
Battery/DC Power) position.
.
.
.
IMPORTANT:
Be sure that the batteries are installed correctly.
Wrong polarity may damage the unit.
WARNING:
- Be sure that the batteries are installed correctly. Wrong
polarity may damage the unit.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
- Only batteries of the same or equivalent type as recommend
are to be used.
- If the unit is not to be used for an extended period of time,
remove the battery. Any old or leaking battery can cause
damage to the unit and may void the warranty.
- Do not dispose of batteries in fire, batteries may explode or
leak.
Do not try to recharge batteries not intended to be recharged;
they can overheat, rupture
and leak(Follow battery manufacturer's directions).
-
3
)
SOLAR POWER
1. Set the Power Source Selector to "SOLAR/CRANK” position.
2. Put the unit in the sunlight, make the solar panel of the unit is
facing to the sun. If the sunlight is strong enough, the Battery
Level Indicator “HI” will be on, the unit can work normally.