Introduction:
The iP2D-BKR module provides the best of both worlds with a dock connector to
charge and play Apple 30-pin iPods, iPhones and iPads plus music streaming via
Bluetooth from any A2DP capable smartphone, tablet, kindle etc. This module is
compatible with all Becker AUX READY radios and replaces optional CD Changer
(if present), but with the storage capacity of these devices, sacrificing the CD
changer should be an easy decision.
An optional remote control is available to operate iOS device while keeping eyes
on the road.
See
Frequent ask questions
at the end of this guide for details.
Installation:
We recommend disconnecting car battery. But before
anything locate and record radio safe code
. Don’t
disconnect battery if radio code is not available, otherwise
radio will cease to operate.
1.
Remove radio from dash to gain access to connectors. A set of radio
removal tools (See
Fig. 1
) is required.
Fig. 1
removal tools
Fig. 2
2.
Slide tools into radio slots
(51)
. (Straight edge facing away). Withdraw
radio by pulling outwards. To release keys simply press retaining
springs. See
Fig. 2. For detailed radio removal click
3.
With radio removed press BLUE plug release tab (See
Fig. 4
) and
disconnect from chamber (
C-3
) (See
Fig. 3
)
Fig. 3
Radio connectors
Note!
BLUE and GREEN plugs are for optional CD changer and if present, both
must be disconnected. YELLOW plug is reserved for amplifier and if present
must
remain connected.
4.
Connect blue plug from installation harness (See
Fig. 4
) to chamber
C-
3
vacated in step 3
