MacElite Setup Guide
Step 3
Installation of the CD Printer and Ink Cartridges.
Place the printer into the printer holding tray located at the top of the drive stack. Holding the printer
with a hand on each side, insert the front of the printer while elevating the back. Then let the back
section “drop into” place softly and slowly. The printer should be securely inserted into the printer
holding tray and should be completely level.
Make certain that your Macintosh is OFF.
Plug the USB printer cable provided with the MacElite into
the rear of the printer and into one of your Macintosh's available USB ports.
Plug in the printer mini DIN control cable (This is similar to a keyboard cable and has connectors on
both ends.) into matching connectors on the rear of the printer and the rear of the MacElite.
Place the AC power adapter that was provided with the CD printer next to the rear of the printer and
plug into a standard 115V AC outlet. Plug the other end into the power connector on the rear of the
printer. The printer will perform a basic internal test and then wait for additional commands from the
operator or the software.
The top button turns the printer on and off. Use the lower button to open and close the CD tray.
When you lift up the front plastic cover of the printer while it is on, the ink cartridge holder will slide into
the center of the opening enabling you to replace the ink cartridges. If the pickarm will not allow the
front plastic cover to open, then you may
gently
push the pickarm downward by applying downward
pressure at the base of the pickarm where it wraps around the column. Never attempt to rotate or push
down on top of the pickarm. Unpack the included ink cartridges. Be sure to remove the tape from the
cartridges.
Do not
touch the metal contacts or ink nozzles. Release the latches on the cartridge
holders. Place the ink cartridges in their respective color-coded holders. Then snap the cartridge holder
latches down on the cartridges. Close the front plastic cover.
Install printer by allowing front section
to rest in place, then lower the
rear section into the tray.
Connect the printer USB
cable to the printer
Connect the printer DIN control cable
from the printer to the MacElite
9
