MacElite Setup Guide
Step 2
Installation of CD Pick Arm
The CD pick arm needs to be installed onto the rotate arm. Remove the pick arm from the bubble wrap
packaging. Included with the arm will be a bag containing two black plastic retainers. These retainers
are used to hold the pick arm onto the rotate arm.
Hold the pick arm in one hand. Place the arm onto the slotted resting tray on the upper section of the
column. Plug in the RJ12 (telephone) type connector.
(NOTE: MAKE SURE THE CONNECTOR
RETAINER HAS SNAPPED INTO PLACE BY PULLING GENTLY ON THE CABLE.)
Then secure the
arm into place by pressing a retainer into each side of the pick arm. These steps can be reviewed in the
pictures shown below.
The pick arm should freely float or pivot from the point where the retainers were installed
`
Locate Pick Arm & Retainers
Step 1
Hold Pick Arm in Place & Connect
RJ12 Connector
Step 2
Install / Press in the Black
Plastic Retainers
Step 3
`
The Pick Arm after Installation
Step 4
If you did not purchase a CD Printer with your MacElite, you may proceed to Step 4. Otherwise, please
read Step 3, Installation of the CD Printer.
8
